Thursday, June 18, 2020

Sketchup Lesson 4 - 3-D Print Simple Designs


I started by making a 25mm x 50mm rectangle and raising it to a height of 25mm. Using the measuring tool I measured where the shapes were going to be. Then when making the shapes I made sure the ones that were going to be holes were 0.5mm bigger than the pegs. Next, I pushed in the holes 15 mm and raised the pegs 14.50 mm, making the holes deeper than the pegs to give them room to fit. To finish I added my name and coloured everything.
I began with a 50mm x 50 mm square. Which I then raised 25mm. Then when making the shapes I made sure the ones that were going to be holes were 0.5mm bigger than the pegs. Next, I depressed the holes 10 mm and raised the pegs 9.5 mm, making the holes deeper than the pegs to give them room to fit. To finish I added my name and coloured everything.

No comments:

Post a Comment